Menu
Your Cart

Powder Coating Procedures

Powder Coating procedures for external and internal structural components.

Inspect the product for flaws or defects, repair as needed

Sandblasting product (galvanized or bare steel) 0.75 - 1.5 mil. Profile compatible with SSPC-SP-10 (NACE 2 - near white metal scraper) for bare steel, SSPC-SP-7 (NACE 4 - Brushing scraper) for galvanized steel.

Preheat the oven to 450 ° F.

Mask teeth, machined surfaces and anything else that's needed.

Clean the product with compressed air.

Put the product in the oven for pre-cooking.

Pre-cook the product at 450 F. Verify product temperature is 375 F on the entire product before applying primer.

Take the product out of the oven and apply 2.5 - 3.5 mil. Zinc rich epoxy primer in powder base produces specifications on hot product so it melts on contact.

Allow the product to cool between 125 ° F and 175 ° F

Apply 2.5 - 3.5 mil. It produces top coat according to powder production properties.

Place the product in the oven at 425 ° - 435 ° F until the entire substrate falls within the curing window indicated by the powder manufacturer.

Remove from oven to cool, check, de-mask and drain.

Wrap and pack the product.

All procedures and work will be done in-house in a controlled environment. This will protect against any external contamination. (Sudden corrosion caused by transportation and weather conditions, road pollutants, etc.).

 

Our site uses cookies for the best service. By visiting the website, you accept the use of cookies.